0
On a 4 cylinder it is on the end of the cylinder head. On a 6 cylinder it is part of the distributor.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you replace the camshaft sensor on a Chrysler Sebring 1996 2.5l v6?
The cam sensor is part of the distributor. You have to replace the entire distributor.
Where is the mass air flow sensor on a 1996 Chrysler sebring convertible?
A 1996 Chrysler Sebring does not have a mass airflow sensor.
How do you reset the battery in a 1996 Chrysler Sebring?
There is no reset on a 1996 Chrysler Sebring.There is no reset on a 1996 Chrysler Sebring.
Where is the crank sensor on a 1996 Chrysler Sebring 2.5?
It is on the top rear of the transmission bell housing.
How do you change the cam sensor on a 1996 Chrysler Sebring 2.5?
You have to buy and replace the entire distributor.
What is wrong if a 1996 Chrysler Sebring computer reads 'cam position sensor no signal'?
There is a problem with the cam sensor or the wiring to it.
Where do you find the throttle position sensor on a 1996 Chrysler Sebring?
It is on the throttle body, opposite of where the cables attach.
Where is the crankshaft position sensor in a 1996 Chrysler Sebring JX 2.5L V6?
It's in the transaxle housing.
How do you replace the cam bearings on a 1996 Chrysler Sebring JXI with a 2.5L V6?
There are no replaceable camshaft bearings. You will need to replace the head or heads.
What are the symptoms when a crank sensor is bad in a 1996 Chrysler Sebring?
The most common would be engine cranks but does not start.
Where is the camshaft position sensor on a 1996 Chrysler Cirrus V6 2.5 liter?
It is in the distributor, you have to buy a distributor to replace.
How do you know if a crankshaft sensor is going bad on a 1996 Chrysler Sebring convertible?
When a crankshaft sensor is bad the engine will not run. The sensor is not usually intermittent, it is either good or bad.
