There is NOT a choke on any fuel injected engine. The coolant temperature sensor does the job of what used to be the choke. When the coolant in the engine is cold, the coolant temperature sensor tells the engine control module and it determines how rich or lean to make the engine run. You can use a scanner to see if it and all the other sensors are doing the job they are meant to perform.
Replace freeze plug in a 1998 ford windstar ?
The fuse box diagram for a 1998 Ford Windstar van is located on the inside cover of the box cover. It can also be viewed within the service manual.
A 1998 Ford Windstar would use refrigerant 134a
According to the 1998 Ford Windstar Owner Guide : If it is equipped with the C/D changer : ( it is located in the center floor console )
It is inside the oil pan on the bottom of the engine block.
There are two catalytic convertors on this model.
on the floor on drivers side, left of brake pedal
it is on the trans,right side you will have to remove cat.converters to access.
there is a button on the end of th gear shift that you simply push in..
On a 1998 Ford Windstar : The 3.8 liter V6 engine ( and the 3.0 ) has a timing CHAIN
In a 1998 Ford Windstar, the door chime is typically located inside the vehicle's dashboard, often near the steering column. It is integrated into the body control module or near the fuse box. To access it, you may need to remove some dashboard panels or the fuse cover. For precise details, consulting a repair manual specific to the 1998 Windstar is recommended.
On a 1998 Ford Windstar : ( # 16 / 20 amp )