answersLogoWhite

0

dont have one,check your slave cylinder for leaks,if ok ,then u need a new clutch.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you adjust clutch on straight drive 1970 f100?

There's normally an adjustment on the clutch rod which activates the clutch fork on the transmission.


How do you tighten a belt on a golf car?

There is no belt adjustment on a golf cart. However, if the belt is too loose, it may be a drive clutch problem, and an adjustment to the clutch can be made.


How do you replace ball joints on 1995 Nissan truck?

how to replace lower ball joints on 1995 4 wheel drive Nissan truck


Why do you have to push really hard on your 1996 Nissan pickup truck clutch in order for it to start?

I have a 2006 Nissan frontier and on mine the clutch safety switch is located at the very bottom of the clutch pedal travel. That is to make sure you push the clutch all the way in when you start so you can't accidentally crank it over in gear and drive into a wall (Seen it done twice by two different coworkers in an older dodge w/o the clutch switch!!)


What causes the car engine drag at drive stop?

Sounds like your clutch is faulty or it may need adjustment.


How do you fix speedometer cable on 1992 Nissan pickup?

Is there a speed senor for my 1992 nissan 2.4L, wheel drive truck?


How do you replace clutch 1980 Nissan 280zx?

pull the drive shaft the trans cross member the trans and its right there


Where is the slave cylinder on the transmission located 1986 on a Nissan truck it is a 1986 Nissan 720 z engine 2.4 front wheel drive?

From the passenger side,get under truck and look at side front of transmission,theres a hole in transmission with a rubber cover and the slave cylinder is bolted onto it with 2 bolts and the clutch fluid line is attached to the slave cylinder,if bad,then it will be leaking.


What is the Gas Mileage in an 1986 Nissan truck four wheel drive V6?

17 MPG.


Why would the clutch pedal of a 1987 Nissan 300ZX non turbo go to the floor and stay there when there was no slippage in the clutch during drive?

Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced. Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced.


Can you remove the AC compressor belt and still drive a 1986 Nissan pic up?

Yes you can remove it and still drive the truck......


1994 Ford F450 diesel When you drive the truck on short trips the clutch works fine when you get on the interstate an drive at least 20 miles an get off you do not have a clutch but will pump up?

The clutch master cylinder (right next to the brake master cylinder) is leaking internaly.