It's located under the dash wher the clutch peddle is attached to the hinge. It's fight next to the break sensor.
Yes, this switch must be activated to allow the engine to start. If this switch has failed, it may function improperly or not at all.
The switch is under the dash connected to the push rod for the clutch master cylinder.
Depends on the year. All Accords' made after 1989 have a hydraulic clutch.
May be on the upper end of the clutch pedal under dash area
no where
The 1989 Honda accord fuel pump relay switch is contained in a square metal box. The switch will have two wires going to it. The switch should be labeled.
The Throttle Position Sensor is located on the throttle body
In the intake manifold plenium, its a 2 wire sensor
Where the cable hooks on to the transmission there should be a little screw what adjusts the cable.
Under the hood, right beside the brake master cylindar. Should be the clutch master cylindar.
On a 1989 Honda Prelude, the clutch hose is typically located between the clutch master cylinder and the clutch slave cylinder. The master cylinder is mounted on the firewall in the engine bay, while the slave cylinder is located on the transmission. The hose runs along the chassis, connecting these two components to facilitate hydraulic fluid transfer for clutch operation. Always refer to a service manual for precise locations and diagrams.
New battery needs a charge? Loose or corroded battery cable? Engine seized? Bad starter Bad starter solenoid? Bad neutral or clutch safety switch?