answersLogoWhite

0

Answer

look behind the glove box

It is behind driver side kick panel, you have to access it from under the hood use 10mm deep well socket to remove harness conector. Remove two nuts one above one below connector,take off rubber seal off the studs ecm is now free,but will may noy come out with removing rear screws from plastic inner fender to give it more room.

User Avatar

Wiki User

15y ago

What else can I help you with?

Trending Questions
Can 12 volt batteries with different amps be connected in series? What would cause a terrible grinding sound when coming to a complete stop at 0-1 mph to happen only occasionally and not with every stop? How do you check transmission fluid for a manual transmission for a 97 Honda civic? Is there any other tricks to changing oil filter? What are the symptons for a bad transmission sensor? Where can I find a 1998 eclipse fuse panel diagram? Why is there no current going to the headlights on the left side on my 1995 J30 Infinity Lights work fine on the right side therefore verifying there in no fuse problem What can you check next? What type of transmission fluid does a 1990 acura integra gs auto tranny use? Where is the cigarette lighter fuse located on a 2004 c230? Where is the fuel cut off switch on a 2004 Mazda rx8? Car will go forward but not in reverse when cold? What is the firing order for a 1989 Dodge Colt? Where is the PCV valve located on the 1995 Suzuki Sidekick? Why do my lights in your 1994 Nissan are not working after changing the battery? What are the uses of lubricant oil? Where is the throttle position sensor located on a Taurus - Sable? Your panel lights are not working and the right front signal light won't work replaced the bulb 3 times? Grand Cherokee headlamps dip wrong way for UK do you have to change or can you adjust? What could be the cause of an annoying whistling noise in your 2007 Jeep Grand Cherokee? What does it mean when o ring blows out of fuel pump 94 Ford F-150?