The coolant temperature sensor on an Infiniti G20 is typically located near the engine block, often on the cylinder head or near the thermostat housing. It's usually a small cylindrical component with an electrical connector attached to it. To access it, you may need to remove some engine covers or components, depending on the model year. Always refer to your specific service manual for precise location details and instructions.
i need to locate knock sensor on a 2000 infiniti g20
in the distributor
located in the distributor
exhaust pipe
R&R tps sensor
Right behind the Cat. toward the back of the car.
How to replace starter on a 95 G20 infiniti?
Yes. The rear bumper cover was the same on the Infiniti G20 from 1999-2002.
Trouble code P0138 means:O2 sensor circuit high voltage (Bank 1 Sensor 2)
Bank one sensor two refers to the oxygen sensor. The bank one sensor two oxygen sensor is on the front side of the engine, after the catalytic converter.
The G20 has two coolant temp sensors, one temp sensor is at the front on the engine, it has two wires and is next to the thermostat housing, this sensor feeds info the the vehicle ECU. The other sensor is one wire feed and situated on the side of the engine (drivers side) this gives info to the temp gauge on the dashboard.
my infiniti g20 needed trans fluid. I did that. then the linkage went out. so now what?