answersLogoWhite

0

The coolant temperature sensor on a Nissan Almera Tino is typically located near the engine's thermostat housing or in the engine block. It's usually a small cylindrical component with an electrical connector. To access it, you may need to remove some engine covers or components depending on the specific engine configuration. Always consult the vehicle's manual for precise location and replacement instructions.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

When was Nissan Almera Tino created?

Nissan Almera Tino was created in 2000.


Reset air bag warning light Nissan almera tino?

Reset air bag warning light Nissan almera tino?Read more:Reset_air_bag_warning_light_Nissan_almera_tino


Does Nissan almera tino 2002 have belt or a chain?

it has sparkles on the belt


Does Nissan almera tino 20002 have a fuel filter in its petrol tank?

no fuel filter


How do you adjust a clutch on a Nissan almera tino?

The clutch is auto adjusting hydraulic system :-)


Where is the pollen filter located on a Nissan almera tino 2005?

Did you check behind the glove vcompartment as in other models?


Where is your Nissan almera tino vin plate?

lift a flap of carpet under the drivers seat, its etched onto the floor pan


How could water get into your car on the floor of the driver's side of Nissan almera tino?

Your probable source here is going to be condensation from the AC evaporator.


Where is the starter motor relay located Nissan almera tino?

In the Nissan Almera Tino, the starter motor relay is typically located in the fuse box under the dashboard, on the driver's side. You may also find it in the engine compartment fuse box. It's advisable to consult the owner's manual for the exact location and diagram specific to your model year, as it can vary.


How do you open the petrol cap on a Nissan almera tino?

The fuel tank lever is located on the right hand side of the drivers seat towards the rear of the driver seat.


Heater motor resistor for a Nissan almera tino?

On my 1998 RHD Tino,it was on the right hand side of the heater box, near the firewall, beside where the clutch pedal would have hung from in a manual car.Apparently, sometimes it is found on the passenger side, behind the glove box, but not in my car.


How do you Change side lamp bulb on Nissan almera tino?

To change the side lamp bulb on a Nissan Almera Tino, start by opening the hood and locating the headlight assembly. Remove the cover or twist the bulb socket counterclockwise to access the bulb. Carefully pull out the old bulb and insert the new one, ensuring not to touch the glass with your fingers. Finally, reassemble the socket and cover, and test the lamp to ensure it’s working properly.