0
It depends on the engine... 2.5L is located under the coil pack/Ignition module on the rear of the motor. 2.8L is located on the rear of the motor, under the rear exhaust manifold. Be careful when taking out the sensor, it has a very small bolt holding it in, and the sensors are known to break off in the block. Very big pain to get the remnants out.
What else can I help you with?
Where is the crank position sensor located on a 2003 Pontiac Sunfire?
2003 sunfire
Crank position sencer location on 2003 Pontiac GTP?
The crank sensor is located behind the hamonic balancer
Where is the crankshaft position sensor located on a 2001 Pontiac sunfire?
on the back of the motor wright below the crank sensor
Where is the Gm 3800 series 3 crank position sensor located?
Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor
Where is the crank shaft position sensor located on a 99 Pontiac Gran Am?
IT SHOULD BE LOCATED UNDER THE MANIFOLD BOLTED TO THE BLOCK
Where is the Crankshaft position sensor located on 2001 Pontiac grand prix 3.8l?
The crank shaft position sensor is located behind the harmonic balancer/crank shaft pully on the front of the engine. You can see the wires for the sensor run behinf the pully into a plastic housing.
Where the crank position sensor is located?
where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine
Where is the crank sensor on a 1989 Pontiac sunbird 2.0?
Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.
Where is the crank sensor on 2003 grand am?
where is crank senser located on 2003 pontiac
Where is crank position sensor located on 1997 C280?
Where is the crank position senson located on the car
Where is the crank position sensor located on a ford 350 xl 5.8 liter?
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
Where is the crank position sensor located on a tacoma?
Should be by crank pulley.
