Under hood, passenger side, lower engine area, above crankshaft pulley, mounted in engine block
They are on the camshaft and crankshaft sprockets
on a 93 Chevy cavalier ls how to get the crankshaft sensor out of the block also can I remove the oil pan to get to the crankshaft sensor
car will not start up
The crankshaft sensor is located on top of the transmission at the passenger side.
The crankshaft position sensor on a 1993 Ford Probe 2.0 SE is located near the bottom of the engine, typically positioned at the rear of the engine block near the transmission bell housing. It is usually mounted on the engine block and may be slightly difficult to access due to its position. To locate it, you may need to remove some components or use a flashlight for better visibility. Always consult the vehicle's service manual for specific guidance and diagrams.
no, they are different body styles.
no, the 89-92 engine/transmissions are different from the 93-97 ford probe.
no
On the Ford Probe 93-97 GT's the knock sensor is located underneath the intake manifold. More specifically it is threaded into a fitting on the deck of the engine block in between the heads in the Valley. Shouldn't be too bad if your an experienced mechanic or a mechanically inclined individual. Hope this helps ya out, and good luck.
Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder
MAF(Mass Air Flow) sensor, TPS(Throttle position sensor) sensor, IAF(Intake air flow) sensor, EGR, leaking, loose or missing vacum hoses...
Yes, year model 93 thru 97 Ford Probe