0
What else can I help you with?
What is a p0340 code on a 2004 Chrysler Pacifica?
No Camshaft Position Sensor Circuit Failure
How do you replace a throttle position sensor in a 2004 Chrysler pacifica?
To replace the throttle position sensor in a 2004 Chrysler Pacifica, first disconnect the negative battery cable to ensure safety. Remove the air intake duct to access the throttle body, then disconnect the electrical connector from the old throttle position sensor. Unscrew and remove the old sensor, then install the new sensor in its place, reconnect the electrical connector, and reassemble the air intake duct. Finally, reconnect the battery cable and start the engine to check for proper operation.
Where is the transmission range sensor located on a 2004 Chrysler pacifica?
It is on the valve body, inside the transmission.
Where is the neutral switch on a 2004 Chrysler Pacifica?
It is inside the transmission, on the valve body. It is called a TRS (trans range sensor).
Location of knock sensor on 2004 Chrysler Pacifica 3.5 L engine.?
It is between the heads, under the lower intake manifold.
Where is the starter solenoid on a 2004 Chrysler Pacifica?
It is on the starter.
Does a 2004 Chrysler Pacifica have 2 Oxygen Sensors?
Yes
How do you remove the thermostat from the housing on a 2004 Chrysler Pacifica?
You pry it out.
What is the recommended gas for a 2004 Chrysler pacifica?
87 octane.
How many oxygen sensors on a 2004 chrysler pacifica?
4
Where is the transmission mount located at for a Chrysler pacifica 2004?
on the transmission
How do you replace fuel filter in 2004 Chrysler pacifica?
There is not a fuel filter to change on a 2004 pacifica. They use the sock in the tanks for that, apparently.
