It looks like a small canister. It will be located either on your firewall under the hood or will be back by your gas tank. If the lines are rusty, use some WD40 on the threads before you begin. Best of luck on your project.
Mounted inside the fuel tank on the top.
left side engine compartment . follow battery cables to the starter
Fuel pump fuse is located in the main fuse block under the hood.
A 1996 Subaru Legacy Outback requires: For automatictransmission: DEXRON III For manual transmission: GL5 75W90 gear oil
http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlits a 1995 but same thing
Will fit Legacy/Outback Model Year 1995 to 1999.
Should fit second generation Legacy/Outback model year 1995 to 1999.....
Directly below the alternator on the block.
There is no such thing as a 1995 subaru outback, the outback package was not offered on a subaru legacy until 1996, you either have a 1996 subaru outback, or you have a 1995 subaru Legacy L or LSI wagon. Both will be covered in most guide books you can pick up at your local autoparts store.
The Engine Control Module (ECM) for a 1996 Subaru Legacy Outback is typically located in the passenger compartment, specifically under the dashboard, near the driver's side. You may need to remove some trim panels to access it. It is usually mounted on the firewall or the side of the center console. Always ensure to disconnect the battery before attempting to access or replace the ECM.
in the engine bay. Passenger side. Near the strut tower.
place the thermostat with the pointed facing out-ward away for the motor.