The fuel pump driver module on a 2002 Ford F-150 4WD is typically located on the driver's side frame rail, near the rear of the vehicle. It is mounted to the frame just above the fuel tank. To access it, you may need to lift the vehicle and remove any protective coverings. Always ensure safety precautions are taken when working under the vehicle.
inside that tank, its atached to the fuel pump assembly
THE FUEL PUMP DRIVER MODULE IS LOCATED ABOVE AND TO THE FRONT OF THE SPARE TIRE.
The Chevrolet
About in the middle of the truck, on the inside of the frame rail on the driver side. If it's in the same area of my 96
on the frame under the driver's door
According to my Haynes manual it is accessed inside the vehicle, behind the right rear trim panel.
Fuel pressure on a 2002 Ford F150 4.2 V6 should be around 40 PSI. When pressure drops too low, fuel is not vaporized properly.
On a gas engine, the fuel filter is part of the fuel pump module in the tank.On a Diesel it is on the driver side of the blockOn a gas engine, the fuel filter is part of the fuel pump module in the tank.On a Diesel it is on the driver side of the block
The fuel pump driver module is located behind the passenger side rear door pillar inside the trunk under the upholstery.
Would be in the distributer or the ignition module
Have you tried the relay or the fuel pump itself? Not sure where the relay is located
it's on the inside of the fram rail about where the driver door is at in front of the fuel tank