Look under vehicle follow fuel line from tank
The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).
The Mazda B2200 truck body did not change much, if at all between 1986 and 1993. There should be no differences in the shape of the engine compartment. -Kyrasis6 Owner of Mazdatruckin.com
Below are attached links discussing the horn on your truck.
Ummm no where??!!?! for one a b2200 is a Mazda pick up and in that case it would be on the drivers side half way back affixed to the inner side of the frame rail :P simalair location on either truck though
Check on the passenger side, near the firewall. In my 91 B2200 it is a plastic inline filter, held in by two hose clamps. Takes about 90 seconds to replace. There is also one at the inlet of the gas tank.
left frame rail between tank and engine
Get a manual on your truck from DISCOUNTAUTOREPAIRMANUALS.COM They are about $9
At the top of the clutch pedal in the cab of the truck.
I have a 92 b2200 with 325k miles. Ibought it brand new.
The air condition system does not have a filter to be cleaned or replaced in the bseries trucks year models1986-1993.Ok
The Mazda Bongo and the B2200 have different differential designs and specifications, so they are not the same. The Bongo, being a van, is designed for different performance and load requirements compared to the B2200, which is a pickup truck. While some components may be similar due to shared Mazda engineering, it's essential to verify compatibility on a case-by-case basis if you're considering parts interchangeability. Always refer to specific part numbers and manufacturer guidelines for accurate information.
It would depend on the truck's condition. The B2200 short bed truck in excellent condition would be about $1,650. The B2200 long bed would be around $1,750 in excellent condition.