the gas float is usually attached to the sending unit inside the gas tank. most cases you need to drop the tank and take the sending unit out the top. however on some cars it can be removed from inside the trunk or under the back seat. a metal ring retains the unit. unplug the wires and hoses then turn the ring counter clock with a hammer and screwdriver. install is the reverse
you have what is called a "float" in your gas tank. If the float is no good, then the fuel gage in your car will say that the car is on "E" when in all actuallity it is full.
You have to drop the gas tank, take the fuel pump off, get a new one, replace it inside the fuel tank, then put it all back up on the car.
Pull the gas tank and replace float but check all wires to the tank first
It is the amount of gas in your turd. Gas is lighter and therefore a turd with more gas will float.
Check your fuel filter and replace it.
You have to remove the gas tank, the pump assambly from the tank, and replace the float sensor.
There are two. They are accessible from under the rear seat cushion with special tools.
Replace sending unit which is located inside gas tank (gas tank must be removed from car).
If gas is coming out of the overflow tube on your CRF250R, it could be due to a stuck float in the carburetor. To fix this issue, try tapping lightly on the carburetor bowl to free up the float. If the problem persists, you may need to clean or replace the carburetor float valve.
Normally you just replace it as it is not cost effective to replace the switch or float assembly
The gauge is part of the fuel pump/float assembly within the gas tank. It is probably a $500.00 repair. It is harmless.
Float valve is sticking allowing gas to go in crankcase . Replace float valve in carb and change the oil and filter .