If you have a look in the bottom of the passenger side foot-well just below the pollen filter you will see a electrical plug unplug it there is one 5.5 millimeter bolt head remove this there are two plastic clips one on there side press and pull one of them is a bit hard to get to and out it comes hope this helps anyone wanting to replace it. its a 5 minute job
How do you replace a fan blower resistor on a vauxal Corsa?
Changing a corsa blower resistor is easy you just have to follow a few steps. First you will have to take the wheels off, and then screw off the caliper, then after screwing off the pads you can replace the corsa blower.
in my 2007 1.2 corsa where is the fuse for the heater
To change the fan resistor on a Corsa B, first, disconnect the battery to ensure safety. Then, locate the resistor, which is usually found behind the glove compartment or under the dashboard near the blower motor. Remove any necessary panels for access, then disconnect the wiring harness and unscrew the resistor from its mounting. Install the new resistor in the reverse order, reconnecting the wiring and replacing any panels before reconnecting the battery.
The green next to the orange http://www.megavaux.co.uk/Upload/ProductPart/1678b-dsc06839.jpg.jpg
is therea fuse for the vauxhall corsa internal blower motor
The heater switch can be replaced on a Chevrolet Corsica by removing the three wires from the back of the switch. Put the wires onto the new switch and return it to its slot.
how do you change a heater matrix on 1.2 corsa 52 plate
Its behind the glove box. Easy to get at by removing 4 torx head screws holding glove box. then take off plastic vent pipe and blower is up inside plastic housing.remove 3 screws and out she drops.
Its behind the glove box. Easy to get at by removing 4 torx head screws holding glove box. then take off plastic vent pipe and blower is up inside plastic housing.remove 3 screws and out she drops.
On my 1994 Corsa you pull the fan control knob to switch on the rear window heater.
To change the heater matrix in a Corsa C, start by draining the coolant from the system. Remove the dashboard and the center console to access the heater matrix located behind the dashboard. Disconnect the hoses from the matrix, remove any mounting screws, and take out the old unit. Install the new heater matrix by reversing these steps, ensuring all connections are secure before refilling the coolant.