answersLogoWhite

0

The engine computer (behind the battery) is the ignition module.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where in your 2000 dodge 1500 ram van is the ignition module?

where is the ignition module located in my 2000 dodge 1500 ram van


Where is the ignition module on a 1992 Dodge Ram 250 van?

The 1992 Dodge Ram 250 ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is a ignition module located on a 1993 dodge colt?

where is a ignitionmodule in a dodge colt a 1993


Where is the ignition control module located on a 1996 dodge neon?

Autozone


Ignition module and pickup on 1993 dodge shadow?

The ignition module in a 1993 Dodge Shadow is responsible for controlling the ignition timing and firing the spark plugs. The pickup, or crankshaft position sensor, detects the position of the crankshaft and provides the necessary information to the ignition module for precise timing. If either component fails, it can lead to starting issues or engine misfires. Regular diagnostics and testing can help identify issues with these components.


Where is the ignition module located on a 98 dodge ram?

The engine computer is located on the passenger side of the firewall.


Where is the ignition control module located on a Dodge Ram 250 full size van?

The ignition module for your van is located under the hood against the firewall. It has a fair size harness connected to it, with a bolt through the center of it to connect it to the module


How do you check the ignition module 1993 dodge stealth?

To check the ignition module on a 1993 Dodge Stealth, start by disconnecting the battery to ensure safety. Then, remove the ignition module from its housing, typically located on the engine. Use a multimeter to test the module's resistance according to the specifications in the service manual, checking both the primary and secondary circuits. If the readings are outside the specified range, the ignition module may need to be replaced.


Where is ignition module located on 1989 dodge Dakota truck 3.9L?

The engine computer is the ignition module. It is the large black box under the hood.The engine computer is the ignition module. It is the large black box under the hood.


Where is the ignition module on a 1989 Dodge van?

Will be located on the firewall. Flat, square box mounted with two screws.


Where is remote start module located on 2008 dodge grand caravan?

behind the ignition switch they go bad often


Where is the ignition control module located on 1986 dodge d150?

to the right of the master cylinder on the driver's side fire wall

Trending Questions
1982 Chevrolet 6.2 Diesel duel fuel tanks. Engine hesitates going up hill when left tank is selected. Where is the in line fuel filter? Headlights 97 Tacoma? What battery goes in a 97 Ford Explorer remote? Can you shift an automatic transmission from over drive to drive while the car is moving? What do you do when fuel is not getting into the fuel injectors? Where is the hydraulic clutch reservoir on a 1992 Chevy pick up? How do you know which headlight bulb on a Honda Pilot? Why do car tires sometimes spin but don't move the car forward when the road is muddy? How do you change the car battery on a 1996 Pontiac Grand prix? What are two advantages of power steering compared to manual steering? Do rechable batteries loose power after time? Where is the fuse for reverse light in a Renault Kangoo? What is the firing order for a 4.3L GMC safari minivan? Why are hazard lights flashing while charging battery on ford fiesta lights flash a few times then stop for few secs then start again? Where is air filter on 2005 sienna? What causes the timing on your 1989 Mazda 2.2 4 cylinder truck to jump from timing mark 1 to timing mark 3? Where is po 133 sensor located on 2002 mercury mountaineer? What kind of brake fluid does a 2002 kia Rio take? Where is the fuel tank selector valve solenoid located p30? When you change a 1993 ford ranger manual trasmission that has a manual speedometer cable to a newer model that doesn't have a cable how can you make the speedometer work?