It is on the manifold towards the firewall, near the passenger seat. After you pull off the metal clip and disconnect the male from the female part, there will only be two wires, red and yellow. Hope this helps.
The 2006 Hyundai tiburon is about as girl as Clint Eastwood
IAT - Intake(or incomming) air temperature sensor. It will be located along the air intake tube. It is usually either on the airbox or right after. Before you get to the mass airflow sensor. It usually just is held in the tube by a grommet. Undo the connector and pull it out.
The sensor should be located on the intake boot(air intake system) or on the intake manifold.
www.hyundaiusa.com. Pls see the answer to the question posted Sep 30, 2006 "Where can you get free technical information for Hyundai cars?" for details.
10w30
5 x 114.3
10w30
On a 2006 Hyundai Tiburon, there are typically two oxygen (O2) sensors: one located upstream (pre-catalytic converter) in the exhaust manifold, and the other downstream (post-catalytic converter) on the exhaust pipe. The upstream sensor is generally found closer to the engine, while the downstream sensor is positioned further along the exhaust system. Accessing these sensors may require lifting the vehicle and working underneath for the downstream sensor.
where is the coolant temp sensor located on a 2006 hyundai sonata
how to install bearing in 2006 hundai triburon
you can go up to 20 stock
The 2006 Hyundai Tiburon GS 2-door hatchback with the 2.0 liter 4-cylinder engine comes with 6 speakers with 80 watts of stereo output. It has an AM/FM stereo and a mast antenna.