the knock sensor is in the center of the engine block (on the back side) just below the exhaust manifold.
This answer may not be correct, the exhaust manifold is on the front of the engine assuming it is a 4cyl. On a 6 cyl, there are two of them, one for each bank of cylinders and they are located underneath the intake manifold on the top of the engine. If you CEL is showing P0325 that is for the Bank one and P0330 is for Bank two. Bank one is the one closest to the fly wheel. Do not buy this part from the dealer, aftermarket sells the same exact item just reboxed.
I4 does not have MAF.
It's screwed in the side of the engine facing the firewall.
The coolant temp sensor for a 1977 Camry is important to the engine running properly. The sensor sends a signal to the computer to keep the air/ fuel mix correct.
No, you can't.
dose 1997 and 1999 of Toyota Camry has any difference
Can a put an engine out of a 1996 toyota camry into a 1997 toyota camry?
Trouble Code P1705 means:NC2 revolution sensor circuit malfunction
Will a 2.2 engine out of a 1996 Toyota Camry fit in a 1997 Toyota Camry? Yes it will fit you just have to change from distributor to coil packs it will fit because i have a 96 Toyota camry with a 2.2L engine from a 99 model.
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
There are 3 Oxygen Sensors on a 97 Toyota Camry with a 3.0 liter v6.An oxygen sensor is mounted on each exhaust manifold (left and right), And the third is mounted on the exhaust pipe after the catalytic converter.
Where is the oil drain plug on a 1997 Toyota Camry V-6 located?
No, it is completely different belt, it is longer too.