There is no oil filter.. The drain plug is on the left side of the bike.
Pull the oil plug located at the base of the oil pan.
Anonymously
To change the oil in a Yamaha SRX-6 park on a level area and unscrew the oil drain plug nut which will allow the oil to drain into proper receptacle. Remove the oil filter and replace the drain nut plug. Replace filter with proper model and add the correct amount of oil according to the dipstick.
Look under the bike for the drain plug under the motor area.
To change the oil on a 1983 Yamaha XJ750, first, warm up the engine briefly to thin the oil, then turn it off and let it cool slightly. Place a drain pan under the engine and locate the drain plug, which is situated on the bottom of the engine case. Remove the drain plug using a wrench, allowing the old oil to fully drain out. After the oil has drained, replace the drain plug, remove the old oil filter, install a new one, and refill the engine with fresh oil through the designated filler cap.
bottom of motor. be a 17mm bolt.
right in the very center of the bottom of the engine
check the manual silly, its not that hard to find!
32:1 to 36:1 but you shouldn't have to mix it. The PW80 comes with a Autolube oil injection system eliminates the need to premix fuel and oil.
I have a Yamaha 350 big bear, and differential drain plug is on the bottom of the differential. Just remove the plug and let it drain, put the plug back in and fill it back up... i use just regular gear oil
The drain plug is located on the left side of the engine. It is close to the bottom, just under the side cover.