4.5 quarts if you are also replacing the oil filter.
Its on the oil filter adapter housing and hard to get to.
Oil leak behind the oil filter it has 3-#10mm bolts that holds it in place Again it's a 92 acura vigor. I need to know is it a gasket or a O-ring? Also is there anything on the back side of this cover plate?
It is on the drivers side of the motor directly below the throttle body and air intake and is positioned behind the alternater.
The oil filter is located under the intake manifold, sideways.. if looking at front of car its on left side just behind the intake... It is on the driver's side. You get to it inside the engine compartment, not from underneath the car.
To change the oil in a 1992 Acura Vigor GS, start by gathering the necessary tools and supplies, including the appropriate oil filter, oil (5W-30 or 10W-30), an oil catch pan, a wrench, and an oil filter wrench. Begin by warming up the engine slightly, then turn it off and let it cool. Remove the oil drain plug and let the old oil drain completely, then replace the plug and remove the old oil filter, installing the new one. Finally, pour in the new oil through the valve cover and check the dipstick to ensure the correct level.
The oil drain plug on a 1993 Acura Legend is 14mm x 1.5
it is a reminder to change the oil.. goes red after 10000 Kms
i had the same problem with oil leaking too, i tried all kind of stop leak. but only "lucas" oil stop leak worked, haven't leaked since. My 92 Vigor had the same issue. It was initially diagnosed as a leaking oil pan gasket. I brought it to Acura and was advised that the leak came from the oil filter adapter assembly seal and not the oil pan gasket. To access this part, the front differential assembly had to come off along with the return hoses.
For b18b1 it's next to the oil filter, on the left of the oil filter when sitting in the car
Where is the oil filtet located on a 92 honda
Sounds like oil filter is the least of your problems