within three inches of the oil filter, it has three wires.
Should be on the back side of the motor(firewall side). Around the oil filter usually about two inches away. It is called an OIl Pressure Sending Unit hope this helps wolverine
It is located behind the distributor.
behind the oil filter
On the 4.0 L OHV engine, the oil pressure sending unit is on the driver's side of the engine, located below the power steering pump.
The Oil Pressure Switch or Oil Sending Unit (which ever you prefur calling it) on 2.5L its located about underneith the Thermostat Housing.
No, a sending unit is for a gauge, and the switch is for a warning light.
The oil pressure sender or switch is located at the rear of the engine, behind the distributor.
The Oil Pressure Switch (Oil Sending Unit) is located on the rear of the motor towards the top. The crank sensor is located next to it if that helps any.
It requires a special socket to fit it.
The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.
I assume this is the oil pressure switch. It's located on the oil filter housing. Unplug the connector and unscrew it.
If it has a V8 engine, the oil pressure switch is located next to where the distrubuter shaft enters the engine.