answersLogoWhite

0

On a 1988 Ford 460 engine, the oil pressure switch is typically located on the lower part of the engine block, near the oil filter. It is usually positioned on the driver's side, close to the rear of the engine. To access it, you may need to remove obstacles like the air cleaner or other components for better visibility and reach.

User Avatar

AnswerBot

3w ago

What else can I help you with?

Related Questions

Where is the oil pressure switch located on 1989 Ford F250 with 460 motor?

on the back of the block on top of the bellhousing mount


What is the spark plug gap for a 1988 ford 460 engine?

.044 inch ( for the 460 in a 1988 Ford truck , according to www . motorcraft . com - no spaces )


Where is the oil pressure switch located on 1997 Ford F250 with 460 motor?

The oil pressure sending unit is on the back of the block just above the bell housing. The unit screws in.


Does the f350 ford 460 engine have fuel injection?

Starting with the 1988 model it did


Where is the oil pressure switch on a ford 460?

The oil pressure switch on a Ford 460 engine is typically located on the engine block, near the oil filter or the rear of the engine, close to the oil pressure sending unit. It can usually be found on the driver's side, just above the oil pan. Accessing it may require moving other components or using a socket or wrench to remove it. Always consult the vehicle's service manual for specific details related to your model year.


Would a 1988 ford 460 engine have fuel injection?

Yes, it is fuel injected.


What is timing set at for a 1988 e-350 Ford 460 engine?

12 degrees BTDC.


What can cause a low oil pressure reading on a 1990 Ford 460 engine?

In order of cost: Fuel in the oil Incorrect oil BAd oil pressure switch internal mechanical wear ( this is the most likly but most expensive.)


What are the tune up specs on a 1988 Ford E-350 with a 460 engine?

what are the carb settings fro a 1988 f350 pickup


Is the bell housing the same on a Ford 460 and a Ford 351?

the bell housing bolt pattern is the same but the flywheel on 460 is thicker and makes they pressure plate hit bellhousing from 351m/400 there for it will not work you have to have a bellhousing from a 429 or 460


How do you test the pressure fuel pump on a 1988 ford f-350 with a 460?

It not an expensive part.. cheap enough to replace if you suspect a problem. But if you must check it, you can hook it up to a 12V battery and get any off the shelf pressure tester.


What is is spark plug gap for 1988 f350 7.5 460?

According to one of Fords websites : A 1988 Ford F-350 , 7.5 liter / 460 cubic inch V8 engine has the spark plugs gapped at : ( .044 inch )

Trending Questions
How do you reset the check engine light on a 2000 Dodge Ram Truck? What spark plugs go in a 1979 Johnson 9.9? What would cause oil to blow out of exhaust? How can you install the battery to 2001 Buick Century? Air bag light stays on 98 ranger - Neither air bag has ever been deployed - Passenger air bag switch is in off position What can I do to fix this problem - why is it on? Can the loss of antifreeze cause you to lose your heat? What would cause a howling sound to come from the engine on a 95 Ford Explorer? How do you remove harmonic balancer on a 5.9? How many gallons of gasoline is produced from a barrel of oil? How do you change brake light in 1996 Buick Riviera? What is zr rated tires? Where is the fuse panel in an Isuzu Ascender? How do you replace the power network box megafuse? Can a mouse ruin a truck clutch? Who invented the first diesel engine? 2003 GMC Yukon XL fuel gauge not accurate and check engine light comes on diagnostic shows lean line in fuel line 1 help? Does the tail lights in the middle suppose to come on when the head lights are on? Why is the tire still loose after the front rotor and wheel bearings have been replaced on a 1999 Chevy Metro? Why would the 21 hp Briggs and Stratton engine on your Husqvarna riding mower seem to have power surges when mowing - oil is fine and air filter is clean choke seems sensitive? Is there a fix for an underpowered 96 Ford Ranger pickup with 30L and automatic transmission It was underpowered when new and is still gutless after reaching the 100000 mark Scheduled service was done?