On a 2002 Chevy Malibu, the oil pressure switch is located on the engine block, typically near the oil filter. It is usually situated on the driver's side and can be accessed from underneath the vehicle or from the top, depending on the engine configuration. To locate it more easily, you may need to remove some components for better visibility. Always consult the vehicle's service manual for specific details and guidance.
Compression ok?
Not unless you BROKE it.
I don't believe there is one on your model. Mark
A bad neutral switch will not allow a car to start. The switch is there specifically to stop someone from starting a car in gear.
To replace the blower switch on a 2002 Chevy Malibu, first disconnect the negative battery cable to ensure safety. Remove the dashboard trim panel surrounding the switch and then unbolt or unclip the switch from its housing. Disconnect the electrical connector from the old switch, then connect the new switch and secure it in place before reassembling the trim panel and reconnecting the battery. Test the new switch to ensure it operates correctly.
No i have a 2002 malibu that had the same problem when i checked it was the park lock switch that was causing it
where is the location of tensioner of 2002 3.1 L Chevy Malibu to adjust if replacing the alternator?
Yes, you can jump start a 2002 Chevy Malibu. Remember to connect the right connections in order to preserve your battery.
In 2002 the Chevy Malibu had a large port 3100 engine producing around 180hp. This engine was used from 2000 to 2003 in this form.
Have it pressure tested, the intake gaskets have probably failed.
where is the tensioner of 2002 3.1 l Chevy Malibu to adjust so that i can remove the belt when replacing the alternator?
where is the tcm on a 2010 chev malibu located