answersLogoWhite

0

Follow the large black plastic tube from where it comes out of the air cleaner over to atop the engine where it eventually goes into the fuel rail. There is a hard plastic housing attached at both ends by clamps. Loosen the clamps and remove this hard plastic housing. Inside you will see several fine wires protruding into the tube. THAT is the O2 (oxygen) sensor.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Diagram of oxygen sensor for 2000 ford focus?

A 2000 Ford Focus oxygen sensor diagram can be obtained from most Ford dealerships. The diagram can also be found in most Ford repair manuals.


Where is the temp sensor on 2000 Ford Focus zetec engene?

Where is the temp sensor on 2000 ford focus zetec engine


You have a 2000 ford focus when you drive it feels like it is going to stall and an engine light comes on?

It is most likely your oxygen sensor


Where is the intake air temperature sensor located on a 2000 Ford Focus?

with the maf sensor


Where is the coolant temperature sensor located on a 2000 Ford Focus zetec?

cooling fan not work on ford focus zetec


Where is the coolant temperature sensor on a 2001 Ford Focus?

Where is the coolant temperature sensor on a 2001 ford focus?" Where is the coolant temperature sensor on a 2001 ford focus Where is the coolant temperature sensor on a 2002 ford focus


Where is the coolant temperature sensor located on a 2000 Ford Focus?

on top of the thermostat housing.


Where is the oxygen sensor located in a Ford Contour 2000?

go to autozone they will check it free


Where is the number 1 oxygen sensor in a 2004 ford focus located?

It is located before the Calaytic converter


Why does the low fuel light come on in a 2000 ford focus ZX3 when the tank is full?

Defective sensor


Where is the oxygen sensor located on a 2000 Ford Ranger XLT?

in the exhaust pipes behind & in front of converters


How do you replace ac pressure sensor 2000 ford focus?

All that you need to do is unscrew if from the suction side and replace it...........