0
What else can I help you with?
Why in a 2000 Jeep Cherokee AC Clutch will not engage. relays good fuses are good but no power to clutch and yes there is power at the clutch relay?
IT IS POSSIBLE THAT THE LOW PRESSURE SWITCH IS BAD. CHECK ON THE LOW PRESSURE SIDE. IT IS EITHER ON THE LINE OR MOST USUALLY ON THE ACCUMULATER (DRYER). UN-PLUG THE PLUG FROM THE SWITCH AND CUT A WIRE ABOUT 3 INCHES LONG. STRIP THE WIRE ON BOTH SIDE AND PLUG THE WIRE IN ON EACH SIDE OF THE PLUG WHERE THE SWITCH PLUGGED IN. TURN THE AIR ON AND SEE IF THE CLUTCH KICKS IN. THIS IS DONE TO BY-PASS THE SWITCH, WHICH IS WHAT KICKS THE CLUCH IN. IF THE CLUTCH KICKS IN, THEN BUY YOU ANOTHER LOW PRESSURE SWITCH.
1987 jeep Cherokee 4.0 liter starts and runs till the clutch is engaged why?
Look all around the clutch pedal to make sure there are no loose wires being rubbed when the clutch is being engaged. If an important wire is being grated on by the clutch, it may be grounding it out, causing your jeep to shut down. I have seen that happen, so that may, or may not be your problem. Good luck.
What would cause the positive connector wire to melt on a 2000 ford focus?
A positive wire is grounded out to the frame someplace on the car. Best take it to someone else to get it fixed.
To jump the ac compresson on a 1995 grand prix to service the ac how do you do that?
There are two wires connected to the clutch pulley at the front of the AC compressor; one is the negative ground wire and the other is positive power to activate the electric clutch. Run a wire of at least 12 gauge (solid insulated house wire or lamp cord is perfect) from the positive battery cable to the positive AC supply. I don't know what the color code is but quickly and lightly brush the jumper on a bare patch on one of the wires. If you get sparks but no sound try the other. The right wire makes the clutch activate with a loud click or "Snap"; assuming it is working properly.
Replace the positive battery cable on a 2000 Pontiac Grand AM?
Disconnect both battery cables. Follow the positive cable on the 2000 Grand Am to the other end, looking at how it was routed. Remove the wire connection, and pull the wire out. Instill the new wire through the same routing, then reconnect the cables.
What kind of clutch does a 2002 Kia Rio have?
They have a wire clutch.
How do you replace clutch pedal assembly on a 2000 Chevy pick up c1500?
There are several videos online that visually illustrate the process of replacing the clutch pedal assembly on Chevy pickups, including the 2000 c1500. Most of them include a combination of unscrewing the push rod and unplugging the wire connection to the clutch interlock.
What color is the trigger wire on a 1989 Jeep Sahara tachometer?
On the 88 jeep the trigger wire at the tach is blue.
Where can you find a radio wiring diagram for a 2000 Chevy Silverado?
left front speaker wire brown is positive.
What is the wiring code for speaker wires on 89 Jeep Grand Wagoneer?
The wiring code for speaker wires in a 1989 Jeep Grand Wagoneer typically follows a standard color scheme: the positive wire is usually dark green, and the negative wire is often brown. For the front speakers, the left speaker may have a dark green wire for positive and light green for negative, while the right speaker may use a dark blue wire for positive and light blue for negative. Always refer to a specific wiring diagram for your vehicle to ensure accuracy, as variations can occur.
97 Mercury mountaineer-you want to add air hornWhat wire do you hook the positive air horn wire to?
positive wire to another positive wire
Where is the Intake Air Temperature sensor located on a 2000 Jeep Cherokee?
it is in the intake manifold by the throttle body and the map sensor. it is a two wire sensor
