answersLogoWhite

0

In the front passenger footwell , behind the kick panel

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the fuel reset button on a 1998 Ford F150?

In the right front passenger footwell , by or behind the kick panel


What do you do to reset the fuel switch on a ford f150?

Locate the switch and press the reset button.


How do you reset the oil change light on a Ford f150?

To reset the oil change light on a Ford f150 you start by pressing the button on the dashboard. After you press the button on dashboard, it will start to cycle through liquid level checks, such as fuel level. When it gets to the oil, press and hold the reset button.


Where it located anti theft reset button on ford f150 1998?

Check owner's manual. If you don't have one copy and paste link below; www.fleet.ford.com/maintenance/owners_manuals


Where is the fuel reset button on a 1993 Ford F150?

under dash on pass side or behind kick panel on pass side


Where is fuel reset switch1998 f150 truck?

The 1998 Ford F150 owners manual shows it as being in the right front passengers footwell , behind the kick panel


Where is the fuel reset button for a 1998 Chevy s10?

Chevrolet doesn't use a fuel pump reset button (inertia switch). That's a Ford thing.


How do you reset oil light on 2012 Ford F150?

After an oil change, the reset light on the 2012 Ford F150 may reset itself. If not, on the left side of the steering wheel use the toggle button to scroll to the settings menu. Press the > button to go to Vehicle Settings. Press > again and scroll to Vehicle. Press > once again and scroll to Oil Life Reset. You can set to any percentage you want from 10-100%. Press and hold the OK button to set.


Where is the Fuel reset switch on a 1986 Ford F150?

There are images available online to help you see where the Fuel reset switch on a 1986 Ford F150 is.


Where is the fuel reset button on a 2003 Ford F150?

check under the carpet between the seats if you have buckets or behind if you have a bench.


Where is the fuel pump reset button on a 1988 ford crown Victoria?

where is the fuel pump reset buton for 1998 camro V6


How do you reset a fuel pump for 1998 ford F150?

To reset the fuel pump on a 1998 Ford F-150, locate the fuel pump reset switch, also known as the inertia switch. This switch is typically found in the passenger side footwell, near the kick panel. Press the red button on the switch to reset it. After resetting, turn the ignition key to the "On" position for a few seconds to allow the fuel pump to prime before starting the engine.

Trending Questions
Why do my turn-signals and brake-lights work w lights off but when lights are on the turn-signals don't work right and nothing works when I hit the brakes? How do you replace the rear turn signal bulb located on a 1996 Dodge Caravan? What is the firing order for a slant 6? Where is the location of the transmission control module TCM on a 2000 Ford Mustang? How do you siphon fuel from a 1989 Olds Cutless Supreme 3.1L that does not allow complete insertion of a siphon hose due to an anti-siphon device? What does an oil light coming on mean when the oil is full? What is the correct tire size for a 1995 Cadillac Deville? Timing settings for 1.7TD Astra van 1999? Does a 1995 Nissan Altima have a timing chain or timing belt? Is your car loud because of your muffler? Where are Larry Page and Sergey Brim from? Where is the daytime running lights control module on a 1996 buick regal? 1995 jeep wrangler you are getting no spark from the coil you have replaced the coil replaced the crank sensor i took out the ecm and swapped it with one from a 1991 the 1991 ran with my ecm mine stil? Do you need to replace your water pump if you change radiator? 2002 cavalier yellow check engine light is turning on why? Replacing a battery in a 1996 Honda passport the Positive and Negative posts unlabled? Where is the fuel filter located on 1999 Chevy 3500 van? What are three main functions of lubricating oil? What does a stp filter s10590 fit? How do you remove and install ring gear from torque converter?