It is mounted to the clutch housing. Have someone push on the clutch pedal and follow the movement of the cable. From the driver side look down towars the clutch housing, it is on top.
where is the fuel filter located on a 91 geo prism?
It is located on the clutch slave cylinder. The slave cylinder is mounted on top of the transmission. Have someone push on the clutch cable and you will see movement on the cylinder.
The Geo Metro was the only Geo to have a 3cylinder engine.
On the firewall, under your master cylinder. That is incorrect: The Oil Filter is located on the block; to the right and above the oil pan.
Underneath the brake master cylinder. Some of what you need to get to is easier if you turn the wheels all the way to the right before you start.
Yes the Geo Prism has ait bags.
In a 1995 Geo Tracker, the slave cylinder is located on the driver's side of the vehicle, mounted on the transmission. It is positioned near the bell housing and attached to the clutch fork. To access it, you may need to remove the transmission or certain components for better visibility and reach. Make sure to consult a repair manual for specific instructions and diagrams.
it's located in the washer holding tank
in the fill resivor attached to the master cylinder assembaly
The Geo Prism is a compact car that was produced by General Motors under the Geo brand from 1989 to 1997. It is essentially a rebadged version of the Chevrolet Prizm, which was developed in partnership with Toyota. The Geo Prism typically features front-wheel drive and is known for its fuel efficiency and reliability. It was available with a range of four-cylinder engines during its production run.
Who cares... those cars suck
It is connected to top radator hose on block