answersLogoWhite

0

it's located in the rear of the transfer case

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the knock sensor on a 1991 Chevy k1500?

It is located right above the starter for a 5.7l V8, not sure for the 4.3 or 5.0, probably the same place


Where is the fuel pump on a 1991 Chevy k1500 located?

In the fuel tank


Where is the water temperature sensor for the gauge cluster located on a 1991 Chevy K1500 305 engine?

There is'nt one on the guage cluster but there is on the motor up by the thermostat housing


Is the Chevy 5.7L v8 ovh 16v a 350ci?

Yes, yes it is! I know i have a 1991 Chevy K1500 with one of them in it.


Will 1992 Chevy 5.7 liter fit a 1991 Chevy silverado K1500?

YES, It will bolt right up with NO modifying.


What type of refrigerant goes into a 1991 Chevy K1500?

R-12 from factory Should be converted to R134


Is there another coolant sensor that would affect the operation of the dashboard temperature gage on a 1991 Chevy K1500 305 the temp sensor next to the thermostat housing has already been replaced?

There is a sensor located between exhaust manifold #1 and #3 (drivers side). This sensor controls the temp gage in a cars interior.


Where is the speed sensor of Chevy Astro van 1991 located?

Speed sensor is located on the tail of the tranny. On the side near the drive shaft. There is an electric connection that clips onto it and is held in by one 10 mm bolt.


What are the interior bed dimensions of a 1991 Chevy k1500 stepside bed?

78 inches long and 49 inches wide


What was the horsepower of a stock 1991 350 K1500 pickup engine with a dual barrel throttle body?

Chevy says about 210hp.


Where is the crank sensor in a 1991 Chevy 5.7l v8?

1991 probably doesn't have a crank sensor, it probably has a reference in the distributor.


Location of the MAP sensor on a 1991 Chevy Blazer?

where the map sensor on 98 blazer?