The vehicle speed sensor is mounted on the transmission, but on 2000 and later models the VSS is combined with the rear axle sensor located on top of the differential. The powertrain control module uses the sensor input signal for several different engine and transmission control functions. The VSS signal also drives the speedometer on the instrument panel.
I believe that 1995 was the last year for a conventional speedometer cable on a Ford Explorer , and then Ford went to an electronic speedometer with a vehicle speed sensor
I believe starting on the 1996 Explorer , it went to an electronic speedometer with a vehicle speed sensor ( VSS ) so it doesn't have a conventional speedometer cable
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
The Mass Air Flow sensor is located on top of the air filter housing on Ford Explorer.
May have replaced the wrong sensor or you have a bad wire in that curcuit. gm Jim
I believe it was 1996 that the Explorers started using an electronic speedometer with a vehicle speed sensor ( VSS ) Since then the Explorers have not had a conventional speedometer cable
The 1998 Ford Explorer 5.0 liter engine IAT sensor is located between the engine and the air filter box. The IAT sensor will be on the air intake hose.
Actually , it doesn't have a conventional speedometer cable , it has an electronic speedometer and a vehicle speed sensor ( VSS ) according to my Haynes repair manual
Bank 2 is the drivers side of the engine in your Ford Explorer Sensor 2 is after the catalytic converter ( downstream )
i don't know the answer
there are several sensor, you can go to autozone.com and find out where they are
The speedometer is driven by the vehicle speed sensor. See "Related Questions" below for more about where to find it, and how to replace one.