somewhere by the handle bars
Universally, they should be near the kick starter and at forward end of the drive belt.
The starter motor
To wire an electric start on a 49 cc gas scooter, you'll typically connect the battery positive terminal to the starter relay, and then from the relay to the starter motor. The negative terminal of the battery should be connected to the scooter frame or directly to the starter motor. Additionally, a push button or key switch can be added to complete the circuit from the battery to the relay, allowing you to engage the starter. Always refer to the specific scooter's wiring diagram for exact connections.
The Starter solenoid is located on the starter itself.
There are 5 possible reasons why the starter quit working on the scooter. First, the battery was bad, second, the starter switch was bad, third, the solenoid was bad, fourth, the the starter motor was bad, and fifth, there was a bad wire. I found another reason, which was the one that fixed my scooters problem and that was the brake switch had gone out. Without the brake switch working the automatic starter won't engage.
Yes, but it is an automatic choke system called an auto by starter.
To hotwire a 50cc scooter, you typically need to connect the two wires leading to the starter motor. These are usually the positive wire from the battery and the wire going to the starter relay. However, this practice is illegal and unsafe, as it can damage the scooter's electrical system and is generally used for theft. It’s recommended to address any ignition issues through proper channels or seek professional help.
where is the starter located on a 2004 chevy suburban
Located on top of the starter
where is the starter located on a hyundai sonata
The engine number on a scooter is typically located on the engine casing, often near the base or on a flat surface of the engine itself. In many models, it can be found on the side or bottom of the engine, sometimes near the kick starter or near the oil drain bolt. If you're having trouble locating it, consult the owner's manual, as it usually provides specific details for your scooter model.
A starter solenoid will be located on top of the starter assembly. A 1996 Toyota Tacoma starter assembly is located under the vehicle next to the passenger wheel.