I would think that 1984 starter construction, should be very similar to my 1981 starter. The stater relay is set of contacts contain within the Solenoid that is mounted on the side of the stater. Typical solenoid wiring configuration is one large gauge wire (usally coming directly from the battery) and two small gauge wires. The one small wire on the "S" terminal applies power and activates the solenoid when you turn the key, closing the starter relay contacts within the solenoid and applies battery power to stater motor, causing the engine to turn over (crank). Assuming the ignition system is functional and the engine is mechanically operational the engine should run.
why is there no answer to this yet...
The starter relay is a smaller cylinder attached to the starter. There should be 2 red wires and a huge black one going to it. The "78 doesn't have a starter relay. It has a starter solenoid mounted on the starter.
Below the blower motor
The high speed blower relay is located on the engine bulkhead bracket next to the blower motor. === ===
The starter relay is on top of the starter.
where is the radio antenna relay located in a 1989 Corvette Convertible
Which relay is the starter relay on a 1994 buick lesabre
The starter relay is built on the starter.
On a 1988 Corvette, the starter interrupt relay is located in the engine compartment, typically mounted on the driver's side near the battery. It is part of the anti-theft system and can be found in a plastic relay box. To access it, you may need to remove the cover of the relay box. Always refer to a service manual for precise locations and troubleshooting tips.
The starter relay on a 1994 Chevy Silverado is mounted on the starter. The starter and relay are usually changed as a single unit.
The starter relay is inside the starter. You will need to replace the starter.
== ==