0
What else can I help you with?
Why does a non grounded plug have four screws for two wires?
Typically the silver screws are neutral, the brass screws are for "hot" (if there are silver screws) There are two on each side because that gives you options. You can feed into the plug box and connect to one pair of screws, then subfeed the next circuit using the other pair. OR you can separate the circuits so that the top and bottom halves of the plug are either on a separate circuit or one half can be on a switch. The options are there if you want to use them. To separate the top and bottom half you'd need to break away the jumper between the top and bottom halves of the plug.
How do you replace spark plug on poulan 3314?
Take out the three screws on the plastic cover on top. It's the black thing on top. When you have it off you will see the plug. Take off the boot and the plug screws out.
Where is the valve cover gasket screws for 1997 Camry?
Most Camrys do not have screws for the cover gasket. Fasteners are rather used. There are 4 of them (4 cylinder). You can find them on each spark plug tube.
the locking plug screws into the headphones, so you can't accidentally pull it out. you can also not screw it on.?
the locking plug screws into the headphones, so you can't accidentally pull it out. you can also not screw it on.
Where does the oxygen sensor plug in?
It screws into the exhaust and plugs into the electrical harness.It screws into the exhaust and plugs into the electrical harness.
How is a german plug wired?
you put the wires under the screws and tighten them
What is the process for plug end replacement on a device?
To replace the plug end on a device, first unplug the device from the power source. Then, use a screwdriver to remove the screws holding the old plug in place. Next, disconnect the wires from the old plug and attach them to the new plug following the manufacturer's instructions. Finally, secure the new plug in place with the screws and plug the device back into the power source.
Where is the 92 dodge Dakota blower resistor?
Under the hood on the passenger side you will see a small box on the firewall with a plug-in...its held in with two screws..remove the plug-in, the screws and pull out the resistor. replacement is the reverse.
What type of screws are typically used for installing drawer slide screws?
The type of screws typically used for installing drawer slides are machine screws or wood screws. Machine screws are commonly used for metal drawer slides, while wood screws are used for wooden drawer slides.
Does the radiator drain plug on a 1998 Chevy truck screw out or pull out?
It screws out.
Where is the blow motor resistor on a Daewoo leganza?
Behind the glovebox toward the firewall, you will see a set of wires (4-I think) that pug into a plug with two small screws holding it in. This is it, remove the plug and screws and pull straight down.
Drain plug for automatic transmission on 1990 miata?
My 93 only had a pan and no drain plug. I had to remove 14 screws and drop the pan.
