answersLogoWhite

0


Best Answer

One of your turn signal bulbs is burned out. Either the front or the back.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why do Turn signals stay on steady and do not flash?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why do my turn signals stay on constantly with no flash?

change the flasher relay


What causes turn signals toflash rapiedly in rear and stay on steady in front.?

usually one or two bulbs are out


When turning on a 1994 cavalier coupe turn signals they stay on but don't flash but the 4 way's do?

you need a new flasher for your singal lights.


Why won't the turn signals work on a 2001 kia rio?

If none of them flash but just come on and stay on the flasher relay is defective. If they do not even come on then the bulb is burnt out.


If turn signals stay solid with no flash and ive changed all the bulbs what could be the problem?

sounds like the hazard light relay they are built into the switch on most models these days


Why do both turn signals flash rapidly sometimes and just stay on sometimes and work properly for a short time on 1996 s-10 blazer?

Most likely bad turn signal flasher or could be a problem in steering column


What causes turn signals to stay on when the lights are on 94 integra?

Your emergency lights are on.


Would a 1998 Volvo v70 hazard flasher switch cause the turn signals to stay illuminated?

Yes. The relay that controls the turn signals is built in the switch.


On my 99 neon sometimes indicator lights stay on steady sometimes flash the way they should Why?

When this happens, wiggle the turn signal stalk. If this fixes the problem, you need a new turn signal switch. Sometimes when you hit the brakes, the lights will come on. This is an indication of a bad switch.


Your turn signals don't flash in your 1986 Oldsmobile cutlass they just stay on when you turn on turn signal?

This usually happens when you have bulbs burned out. Check those first. If they are fine, then you probably need to change the turn signal flasher. If this is a rear wheel drive Cutlass, it has two flasher units. The one mounted in the fuse box is for the emergency flashers. The one for the turn signals is mounted just under the dash next to the steering column. Mine was on the right side of the column.


What causes the turn signal on the left to stay lit and not flash in the front and back on a 1997 Chevy Camaro?

Your blinker is bad, it is located under the center of the dash, get to it by taking the driverside lower panel off. There are two one for the turn signals and one for four ways. Blinkers are not that expensive, i got mine at ace hardware


Can someone tell me why both my turn signals and hazard lights on my 2000 Jetta do not work consistantly They just stay solid at times and do not flash.?

Sounds like hazard flasher needs replaced. there are two one for rerular turn Andone for hazard. Sounds like hazard flasher needs replaced. there are two one for rerular turn And one for hazard.