Wiper motor cogs can wear down and fail to leave the wipers in the lowest position. If the wipers had encountered some resistance they can also slip. It could just be a simple fix.
Check the motor for the wipers.
To adjust the park position of the windshield wipers on a 2003 Grand Am, first, turn the ignition to the "off" position. Then, manually move the wiper arms to the desired park position, usually at the bottom of the windshield. Next, while holding the wipers in place, turn the ignition back to the "on" position and briefly activate the wipers. This should reset the park position to where you’ve adjusted them.
fuse "B" is for front wipers,fuse "D" rear wipers.both rated at 15 amps.
Just replace the wipers
change them
Yes on the front wind screen.
The wiper switch on the ParkAvenue could be bad. Or, the intermittent relay for the wipers could be stuck, causing the wipers to run.
22"
y does my fuse blow when i put on my front wipers the vehichle is a 04 plate defender
Fuse number 53 (rear wiper) and 68 (front wipers)
it is on the same lever you turn your front wipers on with but you twist the the last inch of it
Use the same switch for the front wipers. Once the front wipers are switched on, the rear wiper will come on as well. However, a reverse twist of the switch would turn on just the rear wiper.