four, as it is a four cylinder engine with one spark plug per cylinder.
The 1996 GMC Sierra six-cylinder spark plug gap, is .009. Most spark plugs are pre-gapped by the spark plug manufacturer.
The 1996 Ford Ranger 2.3 L engine has Fords Twin Plug ignition system , so it has ( 8 spark plugs )
Do this one plug at a time, and reconnect that wire so as to not get wires mixed up. REMOVAL Remove spark plug wires from spark plugs with a Spark Plug Wire Remover tool, pull outward on the boot with a slight side-to-side twist. Loosen spark plugs and remove any dirt or foreign material from spark plug areas of cylinder head with compressed air. Remove spark plugs. INSTALLATION Inspect and adjust spark plugs. Spark Plug Gap: 0.042" to 0.046". Install spark plugs. Tighten spark plugs to 9-20 N.m (7-15 lb in). Connect spark plug wires to spark plugs.
Where are the spark plugs on a 1996 Nissan maxima?"
Disconnect the battery, remove the spark plug cables and covers, and remove the old spark plugs. Next, put in the new spark plugs, reconnect the spark plug cables and covers, and reconnect the battery.
the ranger station . com ( no spaces ) Click on Technical Library
My plugs require .44 gap
if it is a v8 it has 8 spark plugs if its a v6 it has 6 spark plugs and ect
Of course it has spark plugs. At list it was diesel.
1.13 mm or .050 That's the gap my plugs are running at on my '95 Zetec (Motorcraft plugs)
On a 1996 Ford Explorer , 4.0 liter V6 engine : The spark plugs are installed in the engine cylinder heads ( you can see where the spark plug wires connect to the spark plugs ) firewall #3 - #6 #2 - #5 #1 - #4 front of vehicle