answersLogoWhite

0

If your bulbs continue blowing out I think I know your problem, I'm assuming you're replacing these bulbs yourself. I'm also going to assume you are not wearing clean rubber gloves when removing the bulb from its packaging and installing on your truck. If this is the case then that bulb is getting covered with the oils and grease that is on your hand from when you scratched your balls earlier today therefore causing said bulb to burn out.

User Avatar

Wiki User

14y ago

What else can I help you with?

Trending Questions
What does BSW for tires mean? Does low brake fluid cause the dash brake light to stay on in a 1999 Ford Taurus? How do you bypass the parking brake for an pioneer 4900dvd in-dash? Where is the fuse located on a 91 Astro van if after replacing the switch on the dash that controls the inside lights it blew the fuse? On a 1994 Miata rear caliper when you back off the adjuster gear the piston does not retract you even removed the adjusting gear and tried a C-Clamp with no luck Do you have to buy a new caliper? What are the car stereo wiring color codes for a 1995 Saturn SL 4 door? What do you do if the check engine light comes back on after replacing the speed sensor? What is the problem the engine cannot start? What words are incorrectly hyphenated A The South-American rain forest B a badly-punctuated sentence C a well-respected man? Never drive avoid sudden steering and braking and always signal your intention to turn or change lanes.? Where is the fuse for the dashboard of a Ford Transit van? Are exhaust manifolds the same for 350 olds and 455 olds? What is the pay scale of auto parts counter people? How do you reset the check engine light in a 1996 Pontiac Bonneville? What is the torque on intake-manifold bolts on 460 engines? Fuse diagram for 2005 dodge magnum? Will a ka24de transmission work on a ka24e? How do you put freon in a 2000 Saturn ls? How do you repair brake light short headlights on no brake lights just the cyclops lights off brake lights and cyclops all bulbs new and correct no obvious wire damage or switch wear? How many quarts of oil in a 1967 327 oil pan?