answersLogoWhite

0

If there is nothing else on the circuit it's a good indicator that the fan motor is failing and probably has worn bearings. Worn bearings will cause an electric motor to pull more current and often blow a fuse. ==Additional Input== The purpose of a fuse it to protect the wiring circuit which it serves from excess current flow, which could severely damage the circuit conductors [wires], OR WORSE, CAUSE A FIRE!!! When a fuse "blows," or burns out, it indicates that there was an OVERLOAD on that circuit, and it did it's job by opening up the circuit. A blown fuse should NOT BE replaced, UNTIL someone has troubleshot the circuit, identified the cause of the overload, and corrected the defect. There are three most probable causes for fuse fuse failure: [1] A short circuit between the "hot" supply wire and ground [bare or cut wire in contact with a bare and sharp metal edge], [2] A defective fuse [which is highly unlikely] [3] Something which causes a "drag" on the blower motor which causes it to draw more current[amps], so much extra, that it excedes the current [amps] rating of the fuse. When the fuse is unable to carry the excess current, it fails by blowing. There are many things which could cause the drag: [1] As described by the previous answer, worn bearings would slow the motor and fan rotation, or [2] A buildup of trash [leaves, candy wrappers, etc.] in the plenum chamber around and in contact with the squirrel cage blower blades]. There may be another, or two, causes I can't think of right now. To fix this problem, you must determine what is causing the excess current demand, and remove/correct the defect. This could include: [1] Repair of wiring involved in a short circuit, [2] Clean out of debris blocking/dragging the fan, [3] Or as a last resort, replacement of the fan motor itself. Hope this helps you to understand and correct the problem. Good luck.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

1994 Mazda Protege keeps blowing 20A fan fuse where could the problem be?

Bad fan motor shorted wire to fan motor shorted switch Disconnect fan motor replace fuse turn on fan and see if fuse blows indicating bad wire to motor if fuse doesn't blow--connect motor if fuse blows bad motor


What fuse controde heather fan motor on Toyota Camry and location on 1996?

i have Toyota 1996 Camry fan blow will not work what fuse make it work and location . fan motor ck out all right


What causes the fuse to blow on a F250 when you turn on the heat?

Ck the heater fan motor resistor .


Would a bad fuse be the only reason your air conditioner and heater will not blow any air at all?

No. It can be a blown fuse, bad fan motor switch, bad fan motor, bad fan motor resistor pack, or a loose or disconnected wire.


Why would the fan control on any speed not blow air The heater blower motor is ok for a Honda Civic?

If you know the fan motor is good but it will not work, first check the fuse. If the fuse is good, then it is either the fan motor switch or the resistor pack that is defective.


94 silhouette will not blow air after having replaced blower motor fan and blower motor resistor. What could be wrong?

Blown fuse? Bad switch?


Why wont the fan blow when turned on in a 1996 Toyota Tacoma?

Nine out of ten times it will be the most obvious answer, that is to check for a blown fuse. Your fusebox under the dash should have a fuse named fan or fan motor. Check it, its probably the one.


Your heater is not blowing air you can feel heat but will not blow?

The heater in all cars use a fan motor to blow the hot air. If you do not feel blowing air the fan is broken and needs to be replaced OR the fuse to the fan motor is burned out and needs to be replaced OR the fan switch that turns on the fan motor is bad OR the wires running to all of these is not connected somewhere. The solution? Check for a fuse in the fusebox that says "Blower" or "Fan". Remove it and put a new one in. If this does not work bring it to someone to test the other things, you cannot do it yourself.


Why wont the AC and heat fan blow in your 98 Jetta you checked the fuse and its fine?

Defective blower motor, switch, or resistor pack.


Why does air conditioning fan does not blow but air is cold?

The blower motor could be shot, or a fuse could be bad. A wire could be disconnected.


Why Motor fan not working?

Could be a faulty fan motor, a faulty fan motor relay, a faulty fan motor temp switch or a blown fan motor fuse.


Why won't my heater blow any air hot or cold?

Check the fuse(s) firstBlower motor fan - might come loose from the motor shaftBlower motor itselfThe reason the A/C or the heat won't come out is probably the fact the fan is busted. My advice is to change the fan.