European cars don't have OBD-II until 2001, diesel engine ecu is not until 2000
The 1991 Ford Mustang does not have an OBDII port, because OBDII was not standardized in the United States until 1996.
OBDII was mandated on all cars by 1996. Some 1994 and 1995 models had an OBDII port, but most (if not all) only provided OBDI information. These were called OBD1.5. I have never seen a 1993 model with an OBDII port.
Assuming that you mean the OBDII port then it is typically under the bonnet / hood with a square plastic cover.
No, take a look under steering wheel. No OBDII port
OBDII started in 1996... OBDI was not as standardised PLL.
OBDII Port below dash/steering wheel.
There is a small panel just underneath of the steering wheel, a little towards the right side. Open up the panel to access the OBDII diagnostic port.
Where is the location of the fuse that controls the OBDII Port on a 1995 F-250?
get a cold air intake reprogram the ECU using OBDII software drop the coil springs just a bit cat-back exhaust install a car computer to run real-time diagnostics through the OBDII port
The 2000 Dodge Neon is a OBD 2 port
Under the dash on the drivers side.
No , there is probably an EEC TEST connection in your engine compartment