First check and make sure your gas cap is tight, if this does not resolve the problem read below. A vacuum hose has become disconnected, more than likely due to having your air filter replaced. The VSC and Check engine light typically don't come on until after 150-200 miles after the vacuum hose was pulled out. The fix: on the right-hand-side of the engine compartment behind the big plastic housing that holds the air filter you will find a black rubber hose that is not connected to anything. Squeeze the finger clamp on the hose and slide the hose back onto the half inch nipple on the back of the air filter's plastic housing. In order for the VSC and Check engine light to be turned off, you will need to open the fuse box, right-side of the engine compartment, and pull the 20 amp EFI fuse for 10 seconds. This will reset the system. The fuse location is marked on the lid of the fuse box, also I believe the EFI fuse is the only 20 amp fuse.
A flashing check engine light is an indication of an engine misfire.
A flashing check engine light is an indication of a misfire.
If the check engine light is blinking that means that an engine cylinder misfire has been detected
An engine misfire has been detected
yes it can. if the check engine light shuts off by itself then chances are either the trouble code is a soft code. A hard code will keep the check engine light on until the problem is fixed and the check engine light is reset.
The check engine light, on your Hyundai Elantra can be reset by removing the fuse. Keep the fuse out for 10 seconds and replace it to its slot.
The check engine light stays on when the computer detects an emissions related failure.
The service engien light (check engine) comes on when the engine computer detects a malfunction and sets a code. You need to have the codes read, diagnosed and repaired to keep the light off.The service engien light (check engine) comes on when the engine computer detects a malfunction and sets a code. You need to have the codes read, diagnosed and repaired to keep the light off.
Disconnecting the battery cable for a few minutes will reset the check engine light. If the light comes back on you will have to get the issue fixed or it will keep coming on.
If it keep on doing it 1 check to see if the choke isn't staying on or reduce the richnes of the mixture. If it keeps on doing it 1 check to see if the choke isn't staying on or reduce the richnes of the mixture.
Have vehicle scanned to determine the problem
The easiest way to reset the 2006 Suzuki check engine light is to remove the fuse. Keep the fuse out for 10 seconds, and replace it to its original slot.