If it is just coming on while you start the car and then going off while the car is running, that is normal. If it is staying on after the car is running, it could be that the cap to your gas tank is not completely closed. The cap has to click atleast 3 times when you close it. I have had this problem on mine before.
it has a problem
If the check engine light it on a 2002 Hyundai Accent on one of the sensors is malfunctioning. The computer is acknowledging this and alerting the driver that there is a problem in the engine.
How do i check the transmission fluid in a manual 99 Hyundai Accent?
disconnect the battery for about 30 sec then reconnect it
Probably need to check the crank sensor (if the check engine light is on) or the fuel pump... I had that problem not too long ago...
go to your Hyundai dealer and make it check
check eBay
because you are one alot of ol timers call the check engine light and idiot light
To replace the power steering belt on a 2001 Hyundai Accent, first, ensure the engine is off and cool. Loosen the tensioner pulley by adjusting the tensioner bolt, then remove the old belt from the pulleys. Install the new belt by routing it around the pulleys according to the belt diagram usually found in the engine bay. Finally, adjust the tensioner to ensure the belt is tight and secure, then check the alignment before starting the engine.
A blinking or flashing check engine light in any Hyundai is indicative of a misfire taking place. It could be due to a faulty ignition.coil, leaky ignition wires or bad or worn spark plugs.
On a 2005 Hyundai Accent, the block heater cord is typically located near the front of the engine, often on the driver's side. It usually comes out from the engine block and may be tucked away near the radiator or along the engine bay. If you're having trouble locating it, check for a small, insulated cord with a plug at the end.
You can find the wiring diagram for a Hyundai Accent 1999 at various auto part stores. You can also check the vehicle's owner's manual.