The fuel pump may stop working when you hit the ignition due to the mechanical failure.
probably when the pump stops working! WOW
About 10 seconds after the engine stops running.
Probably the fuel pump.
no, but there is a relay or fuse for the fuel pump you can pull. there really is no way to "reset" a fuel pump. if it stops working it needs to be replaced, assuming the pump is the cause of the failure
check the ignition module for spark.
Sounds like you have kink in your fuel line somewhere.
Check the fuel pump relay. It's on the passenger side fender between the battery and strutt tower. Have someone turn the ignition to the run position (don't start the engine) while you listen, the fuel pump relay will click when it turns on. Run the vehicle until the pump stops working and check for the click again. If it doesn't click replace the relay.
crank position sensor
When your fuel pump stops working, the engine won't receive the necessary fuel to run, leading to stalling or difficulty starting the vehicle. You may experience a loss of power, unusual noises, or a decrease in fuel efficiency. In some cases, the engine may fail to start altogether. It's essential to address a faulty fuel pump promptly to avoid further damage to the vehicle.
Starts and stops the fuel pump depending on fuel pressure.
Check the 240DL for fuel pressure and good ignition spark. The pressure could be low even though you hear the fuel pump. A problem with the ignition can cause this problem as well.
Your fuel pump is going bad, or you have a loose wire.