The blinking power button on the x5250 typically indicates that the printer is in a standby or error state. This could be due to various issues, such as a paper jam, low ink, or a connectivity problem. Checking the printer's display for error messages or examining the printer for any obstructions can help identify the cause. If the issue persists, consulting the user manual or manufacturer support may provide further guidance.
The hazard flasher activation button has been depressed.
i too have same problem. i noticed that when i turn on head lamp then only red LED keeps blinking.
To turn on the projector, hold the green power button down until the orange light above the button turns green. The picture should come up after while To turn off the projector with the remote, press the gray OFF button once. A message will appear on the screen, "Power Off? Are you Sure?" There will be two choices, yes and no. The yes box will be highlighted yellow, press the gray OFF button once more, and you will here a beep. The green light will turn to a blinking orange. The projector will keep making noise for about 30 seconds know as, "the cooling time." You may unplug the projector when the orange light stops blinking. To turn off the projector with the projector, press the green ON/STANDBY button once. A message will appear on the screen, "Power Off? Are you Sure?" There will be two choices, yes and no. The yes box will be highlighted yellow, press the green ON/STANDBY button once more, and you will here a beep. The green light will turn to a blinking orange. The projector will keep making noise for about 30 seconds know as, "the cooling time." You may unplug the projector when the orange light stops blinking.
The green power indicator light will keep blinking on and off on a new Comcast HD cable box when it is booting up but cannot detect a signal. A technician may need to be called out to correct the problem.
Keep pressing the power button.
Blinking is the way of protecting the lens from dust and other poisonous materials.
2000 cedia the neutral indicator keep blinking and engine lose power
Cats can keep their eyes open without blinking for an average of 30 to 40 seconds.
Press on mode till you see 'AL' at the top. When you see keep pressing on set button. When minute time starts blinking, adjust the time. When you finished setting time, press set button. Alarm will be set.
Animals keep snow out of there eyes by blinking :)
Go to the mode with the blinking white light. Press and hold the button. The light will blink faster and faster. Eventually the light will become solid. Keep the button held down. It will change to green and red (Christmas). Keep going and you will get to red white and blue (fourth of Jul).
No pressure reset button under dash of 4runner 2005. Tire pressure checked. Where else can I look? What else could make light keep blinking?