because the brakes and the engine are separate systems that don't over ride each other
A car goes faster when you accelerate. It slows down when you brake.
The car began to accelerate as the driver pushed the gas pedal to the floor.
A leak in the brake booster is one common reason why a car would stall or hesitate when the brakes are pushed. There could also be an obstruction in the brake line.
Have you released the hand brake?
Hesitation during acceleration on a 1999 Rodeo means that when the gas pedal is pushed down, the car does not immediately accelerate. It may take a second or two for the car to accelerate in this situation.
rear car lights come on as an indication to the drivers in the back that you are about to stop.
You could have a sticky brake shoe or maybe the e-brake is engaged.
It turns the rear brake lights on as a safety feature. The brake pedal is pushed in, causing the fluid to move forward in the brake cylinder,activating a brake light switch. Even if the vehicle is off, the lights will still come on.
Hissing from the brake pedals being push indicates that there is air in the brake system. It also indicates that the brake pads may be wore down and are not able to grab to stop the car.
IT COULD BE A WORN ENGINE MOUNT. TO BE SURE, PUT YOU CAR IN GEAR PRESS THE BRAKE APPLY THE E-BRAKE AND ACCELERATE THE CAR IF YOU FEEL THE SAME SHAKING IS YOUR ENGINE MOUNTS. (BE Careful)
Because the high rpms of the car keep the motor spinning fast so that it is not acting like a compression brake, slowing your car down.
If all the fuses are good, then most likely the brake light switch right on the brake pedal inside the car. Check that.