The miles per gallon display is actually an average of your gas mileage over the truck's life. If it remains the same, it is actually a sign that you have very consistent driving habits.
You can run the overhead, on your 3126 Caterpillar diesel engine, by removing the valve covers. The overhead can be adjusted with the adjusting screws.
typical compression test reading fora diesel engine
You can run the overhead, on your Caterpillar 3176 diesel engine with a Jake brake, by removing the Jake brake. Next, remove the valve cover. Adjust the overhead with the adjustment screws.
I have a 1994 Chevy diesel 6.5 with the same problem, I found that the controller wasn't getting a signal from the computer, by what I'm reading that means that the computer needs replacement. I can't find any better answers than that. Not good.
Yes you can use Siphon but next time try reading the label and don't put in diesel.
According to overhead display, about 14 stop and go and 20 highway
0.84 @20 deg C, but can vary with temperature.
Engine needs to be cold when performing overhead adjustment. Spencer's is .16" intake and exhaust valves closed.
Yes. the computer runs the cruise.
The engine computer is the regulator.The engine computer is the regulator.
you can use range between 0.7500 to 0.8500
It is part of the computer behind the battery.It is part of the computer behind the battery.