It is out of alignment or wheel bearing is loose.
Poor tire alignment will cause wearing on the inside edges of rear and even front tires.
To measure bike tire size accurately, use a tape measure to determine the diameter of the tire in inches. This measurement should be taken from the outer edge of the tire to the opposite outer edge. Additionally, you can also check the tire's sidewall for markings that indicate the size, such as "700x23c" or "26x2.0". These numbers represent the tire's diameter and width in millimeters.
To measure a bicycle tire accurately, use a tape measure to determine the diameter of the tire from one edge to the other. Make sure to measure from the outer edge of the tire for accuracy. This measurement will give you the size of the tire, typically in inches or millimeters.
Your neighbor probably noticed the tread of the tires. If a car needs an alignment, the ware on the tires will be uneven. You will see a worn down strip either on the outer edge or the inner edge of the tire.
The radius of a 24-inch tire is half of its diameter. Therefore, the radius is 12 inches. This measurement represents the distance from the center of the tire to its outer edge.
Your gas mileage will suffer and the tires will wear on the outer edge,unevenly.
To measure bicycle tires accurately, use a tape measure to determine the diameter of the tire from one edge to the other. Make sure to measure from the outer edge of the tire for the most precise measurement. This will give you the correct size of the tire, typically in inches or millimeters.
Wear on the outside both edges is a sign you are running the tires with too little air pressure. Wear in the center is a sign you are over inflating the tires with too much air pressure. Cupping of the tires is a sign of worn shocks or struts. Wear on the inner or outer edge of the tire is a sign that the front end needs aligning. Also feathering of the tire is a sign of a front end out of alignment.
To accurately measure the width of a bike tire, use a ruler or caliper to measure the distance across the tire from one outer edge to the other. Make sure to measure at the widest point of the tire for an accurate measurement.
wha is a inward or outer tilt of the tire?
To measure bicycle tire size accurately, use a tape measure to determine the diameter of the tire in inches. This measurement should be taken from the outer edge of the tire tread. Additionally, you can also check the tire sidewall for markings that indicate the tire size, such as "700x25c" or "26x2.0".
So it can wear out the outer tread faster thus causing faster front tire wear which will help to sell more front tires.