The needle and seat are leaking in your carb and flooding fuel into the engine block. Carb needs to be cleaned and repaired, pressure tested and then drain out oil and oil filter. refill oil and run 10-15 minutes. change oil again and replace oil filter.
22 thousands
It turns clockwise.
22 ounces. Add 4 ounces if it has an oil filter.
regular 30 w
22 ounces. If it has an oil filter add 4 ounces when changing the filter and the oil.
The Briggs and Stratton push mower tune-up kit includes a pack of Stabil, 18 ounce bottle of oil, spark plug and air filter, so the correct answer would be 18 ounces. Always check the oil level level after refilling. According to Briggs & Stratton website it takes 22 ounces. If the engine is equipped with an oil filter add 4 ounces.
The blow-by filter on a 22 hp Briggs and Stratton engine is typically located near the crankcase. It is designed to capture and filter the gases that escape from the crankcase during operation. To find it, look for a small cylindrical or rectangular component connected to the engine's ventilation system. Always consult the engine's manual for specific details regarding the location and maintenance of the blow-by filter.
The valve clearance for a 22 hp Briggs & Stratton engine typically ranges from 0.005 to 0.007 inches (0.127 to 0.178 mm) for both the intake and exhaust valves. It's important to refer to the specific engine model's manual for precise specifications, as there may be slight variations based on the engine type or configuration. Proper valve clearance ensures optimal engine performance and longevity.
For a Briggs and Stratton 22 HP OHV engine, it is recommended to use SAE 30 oil for warmer temperatures or 5W-30 for colder conditions. Always refer to the owner's manual for specific oil recommendations, including viscosity and API service classification. Ensure you check the oil level regularly and change it according to the maintenance schedule for optimal engine performance.
No....Ive had one for well over 10 yrs on a garden tractor.. i just perform regular maintenance and it runs like new
The clearance is 0.004-0.006" and the link to the video on YouTube is below.
For a Briggs and Stratton engine model 128602, the head bolt torque specification is typically 240-260 in-lbs (20-22 ft-lbs). It's important to follow the manufacturer's sequence and guidelines for tightening to ensure proper sealing and engine performance. Always consult the specific service manual for your engine for the most accurate information.