Your rear brake is rubbing on the disk because it is worn out. Your others are probably close to worn out. Soon you might not have any brakes. Then you will step on the brakes and not have any. Hit something cheap when that happens.
--------------
Please check the sliders...on rear disc brake systems the calipers must be free to slide on steel pins. Over time the pins seize and the caliper sticks or binds on the pins. When that happens the caliper will not return to its normal position and will cause the brake pads to drag on the rotor.
Your rear bike brake may be rubbing due to misalignment or wear on the brake pads. To fix it, you can try adjusting the brake caliper position, realigning the brake pads, or replacing worn brake pads.
Your rear bike brakes may be rubbing due to misalignment or wear on the brake pads. To fix this issue, you can try adjusting the brake caliper alignment, replacing worn brake pads, or checking for any debris stuck in the brake mechanism. If the problem persists, it may be best to consult a professional bike mechanic for further assistance.
Could be the rear bearings, brake shoes, brake pads and of course, the suspension. It might help to jack the vehicle up and spin each wheel by hand.
my brake lights stays on wile driving how can i fix it
No. Usually the parking brake is a separate mechanism from the driving brakes, and its usually only found on the rear wheels.
Bad brake light switch, it's on top of the brake pedal under the dash.
When they are wore out. It will depend on driving habits.When they are wore out. It will depend on driving habits.
your brake light switch is probably out
To properly adjust the rear brake on your bicycle for optimal performance, follow these steps: Start by loosening the brake cable tension using the barrel adjuster near the brake lever. Next, adjust the brake pads so they are aligned with the rim of the wheel and are not rubbing against the tire. Tighten the brake cable tension until the brake engages smoothly when the lever is pulled. Test the brake by squeezing the lever to ensure it stops the wheel effectively without any rubbing or squeaking. Fine-tune the adjustment as needed until you achieve optimal braking performance.
Sounds like your handbrake is stuck or rear brake drums are seized. Check out hand barke system and rear brakes.
To install the rear brake sensor on a 1999 Mercedes E320, first, lift the rear of the vehicle and secure it on jack stands for safety. Remove the rear wheel to access the brake assembly, then disconnect the old brake sensor from the brake pad. Install the new sensor by connecting it to the brake pad and ensuring it's properly seated, then reinstall the wheel and lower the vehicle. Finally, check the brake system for proper operation before driving.
It can wear out your rear brakes prematurely if you do it for a long distance because the emergency brake pedal/handle just applies constant pressure on the rear brakes as if you were putting your foot on the brake pedal. It also kills your gas mileage.