answersLogoWhite

0

The engine light stays on when the engine computer has detected an emissions related failure and set a code.

User Avatar

Wiki User

∙ 12y ago
User Avatar

What else can I help you with?

Related Questions

How do you reset the check engine light in a 2002 Chrysler sebring convertible?

You need a scan tool to properly reset the check engine light.


How do you reset the check engine light on a chrysler sebring?

A local auto supply store can reset it for you.


Service engine soon light is on on 1997 Chrysler sebring convwhat needs done?

Have it checked for codes, That is the same as the check engine light.


How do you reset check engine light in 2001 Chrysler sebring?

The only proper way is with a scan tool.


How do you reset the check engine light on a 2008 Chrysler Sebring?

The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.


How do you reset the check engine light on a 1998 Chrysler Sebring convertible?

You can use a scan tool or unhook the battery after repairing the cause of the fault.


What are the symptoms of a bad catalytic converter on a 1998 Chrysler Sebring?

Check engine light, rattle noise, low power, change in fuel economy,


How do I reset the engine light on a 2006 Chrysler sebring?

You use a scan tool after repairing the failure.


What is wrong if your 1995 Chrysler Sebring LXI 'check engine' light comes on after about 10 minutes of driving?

There are dozens of things that turn the light on. TAke it to auto zone and have the codes read.


Does a 2007 Chrysler Sebring have an oil change light?

No the Chrysler Sebring did not have that feature until 2008.


How do you turn off check engine light on 2003 Chrysler Sebring?

To turn off the check engine light on a 2003 Chrysler Sebring, you can try disconnecting the battery. Remove the negative terminal for about 10-15 minutes, then reconnect it. This may reset the system and turn off the light. However, if the underlying issue that triggered the light is not addressed, it may come back on. It's advisable to use an OBD-II scanner to check for specific trouble codes and resolve any issues before resetting the light.


How do you reset check engine light on a 2005 Chrysler sebring sedan?

Disconnect the car's battery for 10 minutes. If a problem does exist, the light will come back on within 75 miles or so.

Trending Questions
SES light is on code is for a misfire in cylinder 1 So I replaced plugs wires o2 sensor coil pack IAC valve fuel injector and had my fuel system cleaned what can it be? Where is the fuse for the power locks? What is the Champion equivalent to the Troy Built 951-10292 Spark plug? Can you use P215 70R16 to replace P215 60R16? What causes a LeBaron 3.0 engine to be hard starting coughs and sputters when running will die while driving. Have replaced fuel filter and has had a complete tune up Could the fuel pump be bad? Which voltage does a compaq presario charger use? What is the fluid capacity for a Chevy Cobalt 2008 2.2 liter auto transmission? My 89' Bronco's windshield wipers stopped working its not the fuse and I don't think it's the motor what else could it be? Where solenoid is located show me a diagram? What tire size is compatible with 2057015? What type of transmission fluid do I use in a 1999 Honda Prelude? How do you change the fuel filter on 1993 Sedan Deville? If the transmission goes in reverse but not forward can it be fixed? How to reduce diesel engine noise? Why doesn't the Clutch engage on a 1996 Chevy cavalier? What would cause the instrument panel lights to stop working on a 2002 Buick Century - I've checked the fuses and the position of the reostat switch? How do you find the right battery for your car? Where is the starter battery on a 2008 Fiat Ducato? What does it mean when the temperature gauge keeps going from cold to hot then back to cold? Is fuel pump access under back seat or under car on 1997 Chevrolet Cavalier?