The trip switch button may not be working due to a malfunction in the circuit breaker, a faulty connection, or an overload in the electrical system. It could also indicate that the circuit has already been tripped and needs resetting. Additionally, if the button is stuck or damaged, it won't function properly. It's advisable to consult a qualified electrician to diagnose and resolve the issue safely.
Next to the odometer is a button. Press it to switch between odo and trip. While in trip, hold it to reset the tripometer.
While holding the "A" trip meter button down, turn the ign switch to "on" ( not start). Hold the trip button down and watch the trip meter count down from - - - - - , - - - - , - - - , - - , - . That's it.
Press in and hold the trip reset button. Switch on the ignition keeping the button pressed.
The trip reset switch on a 1Hz vehicle is typically located on the dashboard, often near the speedometer or instrument cluster. It may be a small button or switch that you can press to reset the trip odometer. If you have the vehicle's manual, it can provide the exact location and instructions for resetting the trip.
To change the trip mileage in a 2004 Cadillac SRX, locate the trip odometer button on the instrument panel, typically labeled "Trip" or "Reset." Press and hold this button until the trip mileage resets to zero. If you want to switch between trip A and trip B, press the button briefly to toggle between the two trip displays.
Press and hold button "A" (positioned right of trip recorder display) Switch ignition ON The word "SERVICE" will appear in the trip recorder display Release button "A" Turn button "B" (positioned left of trip recorder display) to the right to reset the display Switch ignition OFF
To change the trip odometer on a 2010 Volkswagen Jetta, locate the trip reset button on the instrument cluster, usually found near the speedometer. Press and hold the button for a few seconds until the trip odometer resets to zero. If you want to switch between trip A and trip B, simply press the button briefly to toggle between them.
To let you know that it is working and relaying the signal.
To switch from miles to kilometers on the Nissan Xterra, start by turning on the ignition without starting the engine. Then, locate the trip computer button on the dashboard or steering wheel. Press and hold the trip computer button until the display switches from miles to kilometers. Release the button, and the settings should now reflect kilometers.
if it says power button locked hold "<" button and power button till the message goes.(at least a min)
Resetting the maintenance LightSwitch the display to the trip meter A when the engine is running.Vehicles with smart key system:Turn the "ENGINE START STOP" switch off.Vehicles without smart key system:Turn the engine switch to the "LOCK" position.Vehicles with smart key system:While pressing the trip meter reset button, set the "ENGINE START STOP" switch to IGNITION ON mode (but do not start the engine because otherwise the reset mode will be canceled).Continue to press and hold the trip meter reset button until the trip meter displays "000000".Vehicles without smart key system:While pressing the trip meter reset button, set the engine switch to "ON" position (but do not start the engine because otherwise the reset mode will be canceled). Continue to press and holdthe trip meter reset button until the trip meter displays "000000".
My wall furnace has an overheat safety switch. It's up near the top on the side of the unit. If the exhaust vent gets too hot, it will trip the switch off. I use a small screwdriver to reset the switch by pushing the little red button. The switch when activated shuts the thermostat to off. By resetting it, the thermostat will now work.