hazards and turn signals have separate flashers. replace flasher for turn signals
There are 2 separate flashers.jd
turn signal switch needs replaced!
i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs
If the vehicle is equipped with a trailer light plug, the wires for the brake lights and the turn signals have been connected together, which is common, as many trailers do not have separate lights for brakes and turn signals.
the location of the hazard lights is on top of the steering colum.
Your car has 2 flasher relays. One for the turn signals and one for the hazard lights. The one for the turn signals is defective and needs replacing. It is located on the drivers side, under the dash, on the drivers side of the steering column, behind the dash lower panel, mounted at the base of the fuse panel.
The hazard switch itself is bad. The flasher module for the turn signal is built into it. Replace it yourself for 100 dollars(cost of part).
Check the fuse
It has a flasher relay for the signals only.
There are 2 flasher relays. One for the turn signals and one for the hazard lights. The Turn Signal flasher is located on the drivers side, passenger side of steering column, under dash mounted near cigarette lighter. Optionally it can be mounted under the dash on the drivers side of the steering column. The Hazard flasher relay is mounted in the exact same locations.
one of the lights is not working
Its the steering colum